Coal Breaker – Pt V

SWRenderTwo and a half years later .. let’s continue.

I simplified the body, removing all of the rivets and merging everything. Total cost would be $7.10 printed in FUD. I look forward to the day that I can own a desk-top 3D printer capable of printing something like this.

.. in the meantime ..

Via Evergreen
BultupI re-worked it a bit using Evergreen shapes .. #291 .060″ Angle, #292 .080 Angle and .010 sheet. This is quite small .. only about 1x1x1.5 inches.

Leave a Reply

Your email address will not be published. Required fields are marked *

Heads up! You are attempting to upload an invalid image. If saved, this image will not display with your comment.