Flat Belt Pulley – IV

Finished
finished.. and here we go. I lightly sanded the pulley belt surface. There are always at least some texture left from the printing process but that is easily removed with some 600-grit sandpaper – FUD is an acrylic polymer and sands easily. I didn’t seal the plaster before staining with AI and acrylic washes.
with-turbineA test set-up with the turbine. The turbine shaft turns one pulley .. which will be connected to the far pulley via a belt. That pulley will drive another shaft that will connect to a generator system in a power room.
with-turbine2The turbine and pulleys/Station Pillars on the layout. The belt still needs installing .. well .. heck .. as does the shaft into the turbine house.


Leave a Reply

Your email address will not be published. Required fields are marked *

I'm not a spammer This plugin created by Alexei91

Heads up! You are attempting to upload an invalid image. If saved, this image will not display with your comment.